Configuring Ssm-Mapping; Configuring Pim-Sm; Booting Pim-Sm; Configuring Static Rp Address - Zte ZXR10 5900E Series User Manual

ZXR10 5900E Series User Manual (IPv4 Volume)
St-
Command
ep
1
ZXR10(config)#
2
ZXR10(config)#
<group address><source address>
3
ZXR10(config)#
Command
router pimsm
ZXR10(config)#
Command
ZXR10(config-router)#
<acl-number>][priority <priority>]
Example
72 Confidential and Proprietary Information of ZTE CORPORATION

Configuring ssm-mapping

To configure ssm-mapping and take received igmp v2 user as v3
user, use the following command.
ip igmp snooping ssm-mapping
ip igmp snooping ssm-mapping-rule
ip igmp snooping clear-ssm-mapping

Configuring PIM-SM

Booting PIM-SM

Configuring Static RP Address

Configuration should be done of a static RP for a multiple specific
groups and also configure same static RPs for the group on all
PIM-SM multicast routers in the multicast area.
Usually the loopback interface address is used to reduce the net-
work vibration caused by the Up/Down of a physical interface.
After the static RP is configured, it is not necessary to configure
the Candidate-RP for the group.
To configure the static RP address, use the following command.
static-rp <ip-address>[group-list
1. This example shows configuration of static RP 10.1.1.1 for all
groups.
ZXR10(config-router)#static-rp 10.1.1.1
2. Configuration of the static RP 10.1.1.1 for the group
239.132.10.100 is shown below.
Function
This enables ssm-mapping
function globally.
This configures ssm-mapping
rule.
This clears all configured
ssm-mapping rules.
Function
This boots PIM-SM.
Function
This configures static RP
address.