Basic Configuration Of Epon - Zte ZXR10 2900 Series User Manual

ZXR10 2900 Series User Manual
140 Confidential and Proprietary Information of ZTE CORPORATION
Note:
There is big difference between ONU and switch for the function
took by ZXR10 2920 and ZXR10 2928. Therefore ZXR10 2920 and
ZXR10 2928 can't act as ONU and traditional switch at the same
time.

Basic Configuration of EPON

To configure EPON, perform the following steps.
1. To restart PON subboard, use the following command.
Command
set epon reset
zte(cfg)#
2. To enable or disable the port on PON subboard, use the follow-
ing command.
Command
set epon port {enable |
zte(cfg)#
disable}
3. To configure the schedule mode of PON subboard, use the fol-
lowing command.
Command
set epon schedule {SP | WRR
zte(cfg)#
<1-8>}
4. To show link status of PON subboard, use the following com-
mand.
Command
show epon
zte(cfg)#
5. To show PON subboard firmware information and EPON system
configuration information, use the following command.
Function
This restarts PON
subboard.
Function
This enables or
disables the port
on PON subboard.
Function
This configures the
schedule mode of PON
subboard.
Function
This shows the status
of PON subboard.