Vlan Configuration Example - Zte ZXR10 2900 Series User Manual

ZXR10 2900 Series User Manual
80 Confidential and Proprietary Information of ZTE CORPORATION
Command
set vlan-translation
zte(cfg)#
ingress-port <feport-id>{ enable |
disable }
clear vlan-translation
zte(cfg)#
ingress-port <feport-id>
set vlan-translation
zte(cfg)#
ingress-port <feport-id> ingress-vlan
<vlan-list> egress-port <geport-id>
egress-vlan <vlan-list>
show vlan [<vlanlist>]
zte(cfg)#
Note:
The logic link through link aggregation is called as Trunk. One
Trunk is composed of multiple physical ports. Refer to "Basic Con-
figuration of LACP" for more detailed information.

VLAN Configuration Example

1. The following example shows how to configures a VLAN.
Note:
By default, VLAN1 is enabled, all ports are in VLAN1 and in
mode of untag.
Configure VLAN 100. Add untagged ports 1 and 2 and tagged
ports 7 and 8. The detailed configuration is as follows:
zte(cfg)#set vlan 100 add port 1，2 untag
zte(cfg)#set vlan 100 add port 7，8 tag
zte(cfg)#set port 1，2 pvid 100
zte(cfg)#set vlan 100 enable
zte(cfg)#show vlan 100
VlanId : 100
VlanName:
VlanMode: Static
Tagged ports : 7-8
Untagged ports: 1-2
Forbidden ports:
2. The following example shows how to configure the VLAN trans-
parent transmission.
As shown in Figure
through port 16.
B belong to VLAN2, and port 3 of switch A and port 4 of
switch B belong to VLAN3. Members of the same VLAN can
communicate with each other.
VlanStatus: enabled
41, switch A is connected to switch B
Port 1 of switch A and port 2 of switch
Function
This enables or disables
VLAN translation.
This clears the
configuration of VLAN
translation.
This sets VLAN
translation.
This displays VLAN
information.