Zte ZXR10 2900 Series User Manual page 123

Only the node whose attribute is master or edge-master can
be configured.
9. To set preup and preforward time on major level ring, use the
following command.
Command
set zesr domain <domainId>
zte(cfg)#
major-level preforward-timer
<3-600> preup-timer <0-500>
The main-level preforward-time and preuptime must satisfy
the following condition: preforwardtime - preuptime >= 3 !
10. To set preup and preforward time on non major level ring, use
the following command.
Command
set zesr domain <domainId>
zte(cfg)#
level <levelid> seg < segmentid
> preforward-timer <3-600>
preup-timer <0-500>
For both the main level and the level of all the nodes in the zesr
domain, the preforward and preup time must be the same
11. To enable or disable ZESR function in ZESR domain, use the
following command.
Command
set zesr domain <domainId
zte(cfg)#
>{enable | disable}
12. To set ZESR smart-link node, use the following command.
Command
set zesr domain <domainId>
zte(cfg)#
mode smart-link
13. To set ZESR SMART-LINK access port, use the following com-
mand.
Command
set zesr domain <domai
zte(cfg)#
nId>{add | delete}{access-port |
access-trunk}<portId | trunkId>
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 Service Configuration
Function
This sets preup and
preforward time
on major level
ring. By default,
preforward-timer is
3s, preup-timer is 0s.
Function
This sets preup and
preforward time on
non major level
ring. By default,
preforward-timer is
3s, preup-timer is 0s.
Function
This enables or
disables ZESR function
in ZESR domain.
Function
This sets ZESR
smart-link node.
Function
This sets ZESR
SMART-LINK access
port.
111