Zte ZXR10 2900 Series User Manual page 171

wrr1-sp: queue 3 adopts SP mode, queues 2,1,0 adopt
�
WRR mode.
wrr2-sp: queues 3, 2 adopt SP mode, queues 1,0 adopt
�
WRR mode.
sp: queues 3, 2, 1, 0 adopt SP mode.
�
sp: absolute priority mode.
�
wrr: Weighted Round mode.
�
9. To configure the schedule mode of gigabit port, use the follow-
ing command.
Command
set queue-schedule geport
zte(cfg)#
<port-list> session <0,1>
10. To configure traffic supervision mode, use the following com-
mand.
Command
set qos policer counter-mode
zte(cfg)#
{L1 | L2 | L3}
L1: include preamble+IPG+CRC
�
L2: include L2+L3+header+CRC
�
L3: include L3+packet without CR
�
Set counter mode of the qos policer. By default, it works in L2
mode.
11. To configure the committed speed(kbps) of the traffic monitor,
use the following command.
Command
set qos policer <policerid,0-2
zte(cfg)#
55> parameters <32-25165824>
12. To enable or disable the counter function on traffic monitor, use
the following command.
Command
set qos policer < policerid,0-2
zte(cfg)#
55> counter <0-15>{enable | disable}
13. To configure the overspeed disposal of the traffic monitor, use
the following command.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 Service Configuration
Function
This configures the
schedule mode of
gigabit port.
Function
This configures traffic
supervision mode.
Function
This configures
the committed
speed(kbps) of the
traffic monitor.
Function
This enables or
disables the counter
function on traffic
monitor.
159