Table of Contents
Advertisement
Chapter 5 Usage and Operation
zte(cfg)#config router
zte(cfg-router)#
In the Layer 3 configuration mode, the user can configure the Layer
3 port, static router, and
ARP
entities.
To return to the global configuration mode from the layer 3 con-
figuration mode, use the command exit or press <Ctrl+Z>.
NAS Configuration Mode
In the global configuration mode, execute the command config
nas to enter the NAS configuration mode, as shown below:
zte(cfg)#config nas
zte(cfg-nas)#
In the NAS configuration mode, the user can configure the switch
access service, including the user access authentication and man-
agement.
To return to the global configuration mode from the NAS configu-
ration mode, use the command exit or press <Ctrl+Z>.
SNMP Configuration Mode
In the global configuration mode, you can use the command c
onfig snmp to enter the
SNMP
configuration mode, as shown be-
low:
zte(cfg)#config snmp
zte(cfg-snmp)#
In the SNMP configuration mode, you can set the SNMP and
RMON
parameters.
To return to the global configuration mode from the SNMP config-
uration mode, use the command exit or press <Ctrl+Z>.
Cluster Management Configuration
Mode
In the global configuration mode, execute the command config
group to enter the cluster management configuration mode, as
shown below:
zte(cfg)#config group
zte(cfg-group)#
In the cluster management configuration mode, you can configure
the switch cluster management service.
To return to the global configuration mode from the cluster
management configuration mode, use the command exit or press
<Ctrl+Z>.
Confidential and Proprietary Information of ZTE CORPORATION
49
Advertisement
Table of Contents
