Dhcp Client Configuration; Dhcp Client Overview; Basic Configuration Of Dhcp Client - Zte ZXR10 2900 Series User Manual

Port :1
Mac :00.00.02.00.00.11
Channel UserType
-------
1 preview
DHCP CLIENT
Configuration

DHCP CLIENT Overview

ZXR10 2920/2928/2952/2936-FI not only supports the static IP
address configured on layer 3 interface but also supports getting
dynamic IP address from DHCP server, which implements the nor-
mal communication based on layer 3.
At this time, switch takes as DHCP client, the valid use time of the
applying dynamic address is called leased time. Before the leased
time expires, the host should request continuous leasing from the
server, and the address can be used continuously only after the
server accepts the request.
The process of application and lease needn't manual intervention,
the necessary configuration can be done before use.

Basic Configuration of DHCP CLIENT

1. Global Configuration
Command
set dhcp client {enable|disa
zte(cfg)#
ble}
set dhcp client broadcast-flag
zte(cfg)#
{enable|disable}
2. Layer 3 Interface Configuration
Enter layer 3 configuration mode by using the command config
router before configuring DHCP CLIENT on layer 3 interface
mode.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 Service Configuration
MultiAddress
---------- ----------------
225.1.1.1
ChNum :1
Ip :25.1.1.1
ElapsedTime
--------------
0:0:0:12
Function
This enables/disables
DHCP CLIENT at global
configuration mode.
This sets DHCP CLIENT
broadcast-flag.
131