Command Abbreviations; History Command - Zte ZXR10 2900 Series User Manual

ZXR10 2900 Series User Manual
Example
52 Confidential and Proprietary Information of ZTE CORPORATION
listed, and also a brief explanation will be given. Note that a
space must be entered before the question mark. For example:
zte(cfg)#config ?
snmp
router
tffs
nas
group
acl
zte(cfg)#config
4. If you enter a wrong command, keyword, or parameter and
press Enter, the message "Command not found" will be dis-
played on the interface. For example:
zte(cfg)#conf ter
% Command not found (0x40000066)
zte(cfg)#
In the following example, the online help is used to help create a
username.
zte(cfg)#cre?
create
zte(cfg)#create ?
port
vlan
user
zte(cfg)#create user
% Parameter not enough (0x40000071)
zte(cfg)#create user ?
<name >
zte(cfg)#creat user wangkc ?
admin
guest
zte(cfg)#creat user wangkc guest ?
<cr>
zte(cfg)#creat user wangkc guest

Command Abbreviations

In the ZXR10 2920/2928/2952/2936-FI, a command or keyword
can be shortened into a character or string that can uniquely iden-
tify this command or keyword. For example, the command exit
can be shortened as ex, and the command show port shortened
as sh por.

History Command

The user interface supports the function of recording input com-
mands. A maximum of 20 history commands can be recorded.
The function is very useful in re-invoking of a long or complicated
command.
To re-invoke a command from the record buffer, do one of the
following.
enter SNMP config mode
enter router config mode
enter file system config mode
enter nas config mode
enter group management config mode
enter acl config mode
create descriptive name for port
create descriptive name for vlan
create user
user name<length<=15>
create an administrator
create a guest