Zte ZXR10 2900 Series User Manual page 172

ZXR10 2900 Series User Manual
160 Confidential and Proprietary Information of ZTE CORPORATION
Command
set qos policer <
zte(cfg)#
policerid,0-255> exceed-action
{no-operation | drop}
14. To set the global ARP rate-limit, use the following command.
Command
set qos rate-limit arp-All
zte(cfg)#
{enable | disable}
enable: ARP rate-limit is valid for all arp packets.
�
disable: ARP rate-limit is only valid for the broadcast
�
packet.
All the 100M ports are enabled by default.
�
15. To configure ingress rate limit on 100M port, use the following
command.
Command
set bandwidth feport
zte(cfg)#
<portlist> ingress session <0-3> rate
<64-100000>
The parameter session <0-3> is configured as follows by de-
fault.
0: broadcast suppression
�
1: multicast suppression
�
2: rate limit
�
3: user configure
�
16. To configure packet type of port ingress rate limit on 100M port,
use the following command.
Command
set bandwidth feport
zte(cfg)#
<portlist> ingress session <0-3>
packet-type {unknowmulticast |
broadcast | unicast | multicast |
MGMT | ARP | tcp-control | tcp-data |
udp | non-tcpudp}{enable | disable}
17. To configure queue type of port ingress rate limit on 100M port,
use the following command.
Function
This configures the
overspeed disposal of
the traffic monitor.
Function
This sets the global
ARP rate-limit.
Function
This configures
ingress rate limit
on 100M port.
Function
This configures packet
type of port ingress
rate limit on 100M
port.