Zesr Multi-Ring Networking Example; Figure 60 Zesr Multi Ring Networking - Zte ZXR10 2900 Series User Manual

ZXR10 2900 Series User Manual
114 Confidential and Proprietary Information of ZTE CORPORATION

ZESR Multi-Ring Networking Example

F 60 ZESR
IGURE MULTI RING NETWORKING
This example describes how to configure ZESR multi ring network-
ing domain. The multi ring networking composed of 6 switches is
shown above. There are one ZESR primary ring and two hierar-
chical rings.
1. The primary ring is composed of nodes S1~S4. S1 is Master,
P1 is the Primary Port, P2 is the Secondary Port, S2 is the
Transit node, S3~S4 are Edge-Transit node, P3 and P4 are the
edge-port of the two hierarchical rings.
2. The link 1 of hierarchical ring is composed of S6, S3 and S4.
S6 is the Master, P1 is the Primary Port, P2 is the Secondary
Port, S3 and S4 are the assisting nodes.
3. The link 2 of hierarchical ring 1 is composed of S5, S3 and S4.
S5 is the Master, P1 is the Primary Port, P2 is the Secondary
Port, S3 and S4 are the assisting nodes.
The protect instance in the ring is 1, the protected data is VLAN
100 and the protocol VLAN is VLAN 4000.
node configuration of switch:
1. S1 node
VLAN:
zxr10(cfg)#set vlan 100 add port 1，2
zxr10(cfg)#set vlan 4000 add port 1，2 tag
zxr10(cfg)#set vlan 100，4000 enable
zxr10(cfg)#set port 1，2 pvid 100
STP:
zxr10(cfg)#set stp instance 1 add vlan 100
zxr10(cfg)#set stp enable
ZESR: