Zte ZXR10 2900 Series User Manual page 173

Command
set bandwidth feport
zte(cfg)#
<portlist> ingress session <0-3>
queue-priority <queuelist>{enable |
disable}
18. To configure if port ingress rate limit includes management
packet, use the following command.
refers to layer 2 protocol message such as BPDU 01 80 C2
00 00 00)
Command
set bandwidth feport
zte(cfg)#
<portlist> ingress session <0-3>
mgmt-no-ratelimit {enable | disable}
19. To configure if enable each session of port ingress rate limit on
100M port, use the following command.
Command
set bandwidth feport <portl
zte(cfg)#
ist> ingress session <0-3>{enable |
disable}
20. To configure the egress rate limit on 100M port, use the fol-
lowing command.
Command
set bandwidth feport
zte(cfg)#
<portlist> egress {{on rate <64-
100000>}| off}
21. To configure the ingress rate limit on gigabit port, use the fol-
lowing command.
Command
set bandwidth geport
zte(cfg)#
<portlist> ingress {{on rate
<2000-100M/1G>}| off}
22. To configure the egress rate limit on gigabit port, use the fol-
lowing command.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 Service Configuration
Function
This configures queue
type of port ingress
rate limit on 100M
port.
(management packet
Function
This configures if
port ingress rate limit
includes management
packet (management
packet refers to layer
2 protocol message
such as BPDU 01 80
C2 00 00 00).
Function
This configures if
enable each session of
port ingress rate limit
on 100M port.
Function
This configures the
egress rate limit on
100M port.
Function
This configures the
ingress rate limit on
gigabit port.
161