Table of Contents
Advertisement
ZXR10 2900 Series User Manual
66
Confidential and Proprietary Information of ZTE CORPORATION
4. Port configuration about MAC
5. Configuration about multicast
6. Port information view
Port Basic Configuration
On ZXR10 2920/2928/2952/2936-FI, the port parameters such as
auto negotiation, duplex mode and rate, flow control and MAC ad-
dress number restriction and so on, can be configured
To configure the basic port parameters, perform the following
steps.
Command
clear port <portlist>{name |
zte(cfg)#
statistics | description}
create port <portid> name
zte(cfg)#
<name>
set port <portlist>{enable |
zte(cfg)#
disable}
set port <portlist> speedadvert
zte(cfg)#
ise maxspeed
set port <portlist> speedadver
zte(cfg)#
tise maxspeed {speed10 | speed100 |
speed1000}{fullduplex | halfduplex}
set port <portlist> duplex {full
zte(cfg)#
| half|auto}
set port <portlist> speed {10 |
zte(cfg)#
100 | 1000|auto}
Function
This clears port name
or statistics data.
This creates port
description name.
name <name>: The
port name can not
be more than 200
characters. 1~255 is
reserved, which can not
be configured.
This enables or disables
the port. The port is
disabled by default.
This sets the port
speedadvertise.
Port speedadvertise is
to set the negotiation
speed between the
local port and the
other end port. If the
gigabit port is set as
speed100/fullduplex,
the negotiation begins
from the 100Mbps,
fullduplex. When
setting Maxspeed, the
speed is 100Mbps,
fullduplex for megabit
port; the speed is
1000M, fullduplex for
gigabit port.
This sets the working
mode of port as
fullduplex or halfduplex.
This sets the
speed of port as
10M/100Mbps/1000M.
Advertisement
Table of Contents
