Zte ZXR10 2900 Series User Manual page 125

zxr10(cfg)#set zesr domain 1 enable
2. S2~S4 node
VLAN:
zxr10(cfg)#set vlan 100 add port 1，2
zxr10(cfg)#set vlan 4000 add port 1，2 tag
zxr10(cfg)#set vlan 100，4000 enable
zxr10(cfg)#set port 1，2 pvid 100
STP:
zxr10(cfg)#set stp instance 1 add vlan 100
zxr10(cfg)#set stp enable
ZESR:
zxr10(cfg)#set zesr domain 1 add control-vlan 4000
zxr10(cfg)#set zesr domain 1 add protect-instance 1
zxr10(cfg)#set zesr domain 1 add primary-port 1
zxr10(cfg)#set zesr domain 1 add secondary-port 2
zxr10(cfg)#set zesr domain 1 major-level mode transit
zxr10(cfg)#set zesr domain 1 enable
Configuration descriptions are shown below.
1. ZESR port in control VLAN must be configured as tag port.
2. Before enabling ZESR function, STP function must be enabled.
3. The primary port and the secondary port in master node are
different on function. Normally, the primary port is set as for-
warding status, but the secondary port is set as blocking sta-
tus.
4. The primary port and the secondary port in transit node are the
same on function. Normally, they are both set as forwarding
status.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 Service Configuration
113