Viewing Port Information - Zte ZXR10 2900 Series User Manual

ZXR10 2900 Series User Manual
70 Confidential and Proprietary Information of ZTE CORPORATION
Note:
When a port trusts UP and DSCP at the same time, the gigabit port
will trust DSCP firstly, and the 100Mbps port will trust UP firstly.

Viewing Port Information

To view the port information, perform the following steps.
Command
show port [<portlist>]
zte(cfg)#
show port <portlist> vlan
zte(cfg)#
show port <portlist> statistics
zte(cfg)#
[1min_unit | 5min_unit]
show port <portlist> utilization
zte(cfg)#
show port <portlist> qos
zte(cfg)#
show port <portlist> bandwidth
zte(cfg)#
session <0-3>
show port <portlist> brief
zte(cfg)#
One end is auto-negotiation port. Another end is forced rate port.
The joint result is shown below.
Auto-ne-
gotiation
10M Full
port
100M
10M Half
auto
1000M
10M Half
auto
Forced rate port
10M Half 100M Full
10M Half 100M Half
10M Half 100M Half
Function
This displays the
configuration and work
state of the port.
This displays Vlan
information of the port.
This displays statistics
information of the port.
This displays utilization
statistics of the port.
This displays the QoS
configuration on a port.
This displays the
bandwidth information
on a port.
This displays the brief
information of a port.
1000M
100M Half
Full
joint un-
100M Half
success-
fully
1000M
100M Half
Full