Basic Configuration Of Sqinq; Sqinq Configuration Example - Zte ZXR10 2900 Series User Manual

ZXR10 2900 Series User Manual
90 Confidential and Proprietary Information of ZTE CORPORATION

Basic Configuration of SQinQ

To configure SQinQ, perform the following steps.
Command
set sqinq-session <1-256>
zte(cfg)#
customer-vlan <vlanlist> uplink-vlan
<1-4094>
set policy policing in
zte(cfg)#
sqinq-session <1-256> policer <0-255>
clear policy policing in
zte(cfg)#
sqinq-session <1-256>
set policy statistics in
zte(cfg)#
sqinq-session <1-256> counter <0-31>
clear policy statistics in
zte(cfg)#
sqinq-session <1-256>
set policy mirror in
zte(cfg)#
sqinq-session <1-256> analyze-port
clear policy mirror in
zte(cfg)#
sqinq-session <1-256>
set port <portlist> sqinq-session
zte(cfg)#
<sessionlist>{enable | disable}
clear sqinq-session
zte(cfg)#
<sessionlist>
show sqinq-session
zte(cfg)#
[<sessionlist>]
Note:
When configuring SQinQ, policy configuration of SQinQ refers to
the related description about QoS.

SQinQ Configuration Example

As shown in Figure
(Switch A and Switch B) in Service Provider Network. Port 24 of
Switch A is connected to port 24 of Switch B. Vlan1-200 is in port
1–6 of Switch A which communicate with port 1–3 of Switch B in
which Uplink vlanid assigned as 100. Vlan201-4094 is in port 1–6
of Switch A which communicates with port 4–6 of Switch B in which
Uplink vlanid assigned as 200. CustomerPort of Switch A is untag
port only for Vlan1.
47, there are two switches of ZXR10-2952
Function
This configures SQinQ
session.
This configures traffic
rate limitation.
This clears traffic rate
limitation.
This configures traffic
statistics.
This clears traffic
statistics.
This sets traffic mirror.
This clears traffic mirror.
This applies SQinQ
session on port.
This clears the
configuration of SQinQ
session.
This shows SQinQ
session.