Zte ZXR10 2900 Series User Manual page 199

Command
set ethernet-oam port
zte(cfg)#
<portlist> period <1-10> timeout
<2-20> mode {active | passive}
The parameter period <1-10>: discovery period, 1 represents
10ms. 2 represents 20ms and so on. By default, 10 represents
100ms.
The parameter timeout <2-20>: timeout, by default it is 5
seconds
The parameter mode [active | passive]: discovery mode, it
is active by default.
4. To start or stop OAM remote-loopback function on port, use
the following command.
Command
set ethernet-oam
zte(cfg)#
remote-loopback port <portlist>{start
| stop}
The prerequisites of enabling this function is that the global
OAM function has been enabled, the OAM function has been
enabled on destination port, and the OAM discovery process
has been completed.
5. To set remote-loopback timeout value on port, use the follow-
ing command.
Command
set ethernet-oam
zte(cfg)#
remote-loopback timeout <1-10>
The parameter timeout: the default is 3s.
6. To enable or disable link monitor function, use the following
command.
Command
set ethernet-oam port
zte(cfg)#
<portlist> link-monitor {enable |
disable}
7. To configure the symbol period event which is used for link
monitor, use the following command.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 Service Configuration
Function
This configures OAM
discovery period,
timeout range and
mode on port.
Function
This starts or stops
OAM remote-loopback
function on port.
Function
This sets remote-
loopback timeout
value on port.
Function
This enables or
disables link monitor
function.
187