Basic Configuration Of Acl - Zte ZXR10 2900 Series User Manual

ZXR10 2900 Series User Manual
148 Confidential and Proprietary Information of ZTE CORPORATION
source MAC address, destination MAC address, source
VLAN ID and 802. 1p priority value.
v. Global ACL: Match source IP address, destination IP ad-
dress, IP protocol type, TCP source port number, TCP des-
tination port number, UDP source port number, UDP des-
tination port number, DiffServ Code Point (DSCP), source
MAC address, destination MAC address, source VLAN ID
and 802.1p priority value.
5. Each ACL has an access list number to identify. The access list
number is a number. The access list number ranges of different
types of ACL are shown below:
Basic ACL: 1~99
�
Extended ACL: 100~199
�
L2 ACL: 200~299
�
Hybrid ACL: 300~399, support IPV6
�
global ACL: 400
�
Each ACL has at most 500 rules and the range is 1-500.

Basic Configuration of ACL

To configure ACL, perform the following steps.
1. To create a basic ACL instance, use the following command.
Command
config acl basic number
zte(cfg)#
<acl-number>
2. To create an extended ACL instance, use the following com-
mand.
Command
config acl extend number
zte(cfg)#
<acl-number>
3. To create a L2 ACL instance, use the following command.
Command
config acl link number
zte(cfg)#
<acl-number>
4. To create a Hybrid ACL instance, use the following command.
Function
This creates a basic
ACL instance.
Function
This creates an
extended ACL
instance.
Function
This creates a L2 ACL
instance.