Figure 76 Remote Loop Network - Zte ZXR10 2900 Series User Manual

ZXR10 2900 Series User Manual
190 Confidential and Proprietary Information of ZTE CORPORATION
F 76 R L
IGURE EMOTE OOP
Configuration of switch A:
zte(cfg)#set ethernet-oam en
zte(cfg)#set ethernet-oam port 1 en
Configuration of switch B:
zte(cfg)#set ethernet-oam enable
zte(cfg)#set ethernet-oam port 2 enable
zte(cfg)#show Ethernet-oam port 2 discovery
PortId 2: ethernet oam enabled
Local DTE
-----------
Config:
Mode : active /*the port mode must be active, or the discovery is failure*/
Period : 10*100(ms)
Link TimeOut : 5(s)
Unidirection : nonsupport
PDU max size : 1518
Status:
Parser : forward
Multiplexer : forward
Stable : yes
/*yes represents that discovery succeeds. no represents discovery fails.*/
Discovery : done
/*discovery succeeds. "undone"represents that discovery fails*/
Loopback : off
PDU Revision : 92
Remote DTE /*the remote device information*/
-----------
Config:
Mode : active
Link Monitor : support
Unidirection : nonsupport
Remote Loopback : support
Mib Retrieval : nonsupport
PDU max size : 1518
Status:
Parser : forward
Multiplexer : forward
Stable : yes
Mac Address : 00.d0.d0.29.28.02
/*the system MAC of the remote device.
The MAC address is 00.00.00.00.00.00 when discovery fails.*/
PDU Revision : 967
zte(cfg)#set ethernet-oam remote-loopback port 2 start
zte(cfg)#show ethernet-oam port 2 discovery
PortId 2: ethernet oam enabled
Local DTE
-----------
Config:
Mode : active
Period : 10*100(ms)
Link TimeOut : 5(s)
Unidirection : nonsupport
PDU max size : 1518
Status:
Parser : discard /*the parser state is discard*/
Multiplexer : forward
Stable : yes
Discovery : done
Loopback : on(Master)
/*the local is the active originator (Master). The other end displays as slave.*/
N
ETWORK
/*the local device information*/