Zte ZXR10 2900 Series User Manual page 154

ZXR10 2900 Series User Manual
142 Confidential and Proprietary Information of ZTE CORPORATION
This command is valid only after ZXR10 2920/2928 added with
PON daughter card and acting as ONU device.
Caution:
Although ZXR10 2952 and ZXR10 2936-FI provide this com-
mand, but the two types can't provide the function of adding
with PON daughter card. Therefore this command is invalid for
ZXR10 2952 and ZXR10 2936-FI.
2. VLAN Initialization Configuration
Command
show vlan
zte(cfg)#
After the switch added with PON daughter card, the switch acts
as ONU device, all VLANs (1-4094) are enabled. The port 1-19
are added into VLAN 1 with UNTAG, and they are added into
VLAN 2-4094 with TAG. Use the show vlan command to show
all Vlans information.
When the switch does not add with PON daughter card, only
VLAN 1 is enabled . Port 1-18 are added into VLAN 1 with
UNTAG. Use the show vlan command to show the information
of VLAN 1.
Example:
The following example shows that daughter card is added with
ZXR10 2920/2928.
zte(cfg)#show vlan
VlanType: 802.1q vlan
VlanId : 1
VlanName:
VlanMode: Static
Tagged ports
Untagged ports
Untagged trunks : 1-15
Forbidden ports :
VlanId : 2
VlanName:
VlanMode: Static
Tagged ports
Tagged trunks
Untagged ports
Forbidden ports :
VlanId : 3
VlanName:
VlanMode: Static
Tagged ports
Tagged trunks
Untagged ports
Forbidden ports :
VlanId : 4
VlanName:
VlanMode: Static
Tagged ports
Tagged trunks
Untagged ports
VlanStatus: enabled
:
: 1-19
VlanStatus: enabled
: 1-19
: 1-15
:
VlanStatus: enabled
: 1-19
: 1-15
:
VlanStatus: enabled
: 1-19
: 1-15
:
Function
This shows all VLANs
information on switch.