Table of Contents
Advertisement
ZXR10 2900 Series User Manual
Network Figure
and Description
Configuration
Procedure
Configuration
Process
144
Confidential and Proprietary Information of ZTE CORPORATION
F
67 EPON C
IGURE
ONFIGURATION
ZXR10 2928 adds with PON daughter card and connects with op-
tical splitter through the optical port on PON daughter card. The
optical splitter connects with OLT device.
1. Configure service of ONUZXR10 2928 on OLT.
2. Check service configuration on ONU.
The following ONU configurations are performed by OLT.
1. Add ONU into VLAN300. Configure port 1 of ONU to adopt VLAN
transparent transmission mode on OLT.
2. Configure port 2 of ONU to adopt TAG mode, the priority is the
default value, VID is 100.
3. Configure port 3 of ONU to adopt VLAN translation mode, the
default vlan is VLAN100.
4. Create translation rule.
VLAN 200.
5. Enable the IGMP Snooping function to monitor VLAN1000.
View the above configurations on ONU device.
zte(cfg)#show port 1 vlan
PortId
: 1
Tagged in vlan
: 2-999,1001-4094
Untagged in vlan : 1
zte(cfg)#show port 1 vlan-mode
Port 1 Vlan-mode:Transparent-mode
/*The transparent transmission mode of port 1 has been valid.*/
zte(cfg)#show port 2 vlan-mode
Port 2 Vlan-mode:Tag-mode
/*The configuration of port 2 is valid.*/
zte(cfg)#show port 3 vlan-mode
Port 3 Vlan-mode:Translation-mode
/*The configuration of port 3 is valid.*/
zte(cfg)#show port 3
PortId
: 3
PortParams:
PortEnable
: enabled
DefaultVlanId
: 100
/*the default vlan is vlan100.*/
Multicastfilter: disabled
SpeedAdvertise : MaxSpeed
PortMacLimit
: disabled
MacLearning
: enabled
FixMac
: disabled
RecoverTime
: none
PortVlanJump
: disabled
PortStatus:
PortClass
: 802.3
Duplex
: half
E
XAMPLE
Translate the flow of VLAN1000 to
Tag value: 100
MediaType : 100BaseT
PortAutoNeg
: enabled
FlowControl
: enabled
Security
: disabled
Mdix
: auto
UnknownFilter
: disabled
Accept-Frame
FixMode
Link
Speed
: untag-frame
: none
: down
: 10Mbps
Advertisement
Table of Contents
