Configuring Cluster - Zte ZXR10 2900 Series User Manual

Command
set ztp hopdelay
zte(cfg-group)#
<1-1000>
set ztp portdelay <1-100>
zte(cfg-group)#
show ztp
zte(cfg)#
show ztp mac <HH.HH.HH.HH.H
zte(cfg)#
H.HH>
show ztp device [<idlist>]
zte(cfg)#

Configuring Cluster

After specifying the command switch, network topology informa-
tion is got by ZDP/ZTP. Consequently, the cluster management
and monitoring are implemented. Unique ID of a cluster consists
of VLAN where cluster is located and MAC address of command
switch.
Command
config group
zte(cfg)#
set group candidate
zte(cfg-group)#
set group independent
zte(cfg-group)#
set group commander
zte(cfg-group)#
ipport <0-63>[ip-pool <A.B.C.D/M>]
set group add mac
zte(cfg-group)#
<HH.HH.HH.HH.HH.HH><1-255>
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 8 Network Management
Function
This sets the hop delay
for forwarding topology
requests.
This sets the port delay
for forwarding topology
requests.
This displays ZTP
configuration.
This displays detail
information of specified
device according to
MAC address.
This displays
the configuration
information of ZTP
according to the device
ID.
Function
This enters cluster
management
configuration mode.
This configures a switch
as candidate switch.
This configures a switch
as independent switch.
This sets a command
switch, specifies a layer
3 port number for
cluster management
and sets IP address
pool for user cluster
management.
This adds a member
based on device MAC
address and specifies
member ID number.
209