Configuring Garp/Gvrp; Garp/Gvrp Configuration Example; Figure 42 Gvrp Configuration Example - Zte ZXR10 2900 Series User Manual

ZXR10 2900 Series User Manual
82 Confidential and Proprietary Information of ZTE CORPORATION

Configuring GARP/GVRP

The GARP/GVRP configuration covers the following contents.
Command
set garp {enable | disable}
zte(cfg)#
set garp timer{hold|join|leave
zte(cfg)#
|leaveall}<timer_value>
show garp
zte(cfg)#
set gvrp {enable | disable}
zte(cfg)#
set gvrp port <portlist>{enable
zte(cfg)#
|disable}
set gvrp port <portlist>
zte(cfg)#
registration{normal|fixed|forbidden}
set gvrp trunk <trunklist>{enab
zte(cfg)#
le|disable}
set gvrp trunk<trunklist>
zte(cfg)#
registration{normal|fixed|forbidden}
show gvrp
zte(cfg)#

GARP/GVRP Configuration Example

As shown in Figure
port 1. By configuring GVRP, the two switches can register each
other and refresh their VLAN table.
F 42 GVRP C
IGURE ONFIGURATION
42, switch A connects with switch B through
E
XAMPLE
Function
This enables or disables
GARP function. By
default GARP is
disabled.
This sets GARP
timer.The parameter
<timer_value> takes
the fixed value 100.
This shows the
configuration of GARP.
This enables or disables
GVRP function.
This enables or disables
GVRP function on port.
This configures type of
GVRP registration on
port.
This enables or disables
GVRP on trunk port.
This configures GVRP
registration type on
Trunk port.
This views GVRP
configuration
information including if
GVRP can be enabled
and GVRP configuration
status of each port and
each Trunk port.