Interface Configuration; Basic Port Configuration - Zte ZXR10 5900 Series User Manual

4
C h a p t e r

Interface Configuration

Table of Contents
Basic Port Configuration .....................................................29
Port Mirroring Configuration ................................................37
Loopback Detection Configuration ........................................40
DOM Configuration ............................................................42

Basic Port Configuration

The ZXR10 5900/5200 provides GE and XGE ports
� The GE electrical port supports full/half duplex, 10/100/1000
M adaptation and MDI/MDIX adaptation. It woks in auto-ne-
gotiation mode by default, consulting work mode and rate with
the peer end.
� The GE optical port must work at 1000 M full duplex, it can't
be configured duplex mode and rate but can be configured to
work in the auto-negotiation mode.
�
The XGE electrical port supports 10000M full duplex, it can't be
configured to work in auto-negotiation, duplex mode and rate.
�
The XGE optical port supports 10000M full duplex, it can't be
configured to work in auto-negotiation, duplex mode and rate.
The system automatically adds ports: When you insert an inter-
face board to a proper slot and start the board, ports of the board
are automatically added to the port list.
Note:
The GE port and XGE port can't support hot swap.
ZXR10 5900/5200 names ports as follows:
<Port type>_<Slot No.>/<Port No.>
� <Port type> :
(10000M Ethernet interface).
� <Slot No.>
ZXR10 5924/5224 only has one slot.
ZXR10 5928/5228/5928-FI/5228-FI/5952/5252 has 5 slots.
There are 4 slots at the back of device. Slots numbered from
Confidential and Proprietary Information of ZTE CORPORATION
gei (1000M Ethernet interface) and xgei
29