Zte ZXR10 2900 Series User Manual page 174

ZXR10 2900 Series User Manual
162 Confidential and Proprietary Information of ZTE CORPORATION
Command
set bandwidth geport
zte(cfg)#
<portlist> egress {on rate <281-100M/
1G>[burstsize <4-16380>]}| off}
The parameter burstsize <4-16380>: the unit is kbyte.
23. To configure packet type of port ingress rate limit on gigabit
port, use the following command.
Command
set bandwidth geport
zte(cfg)#
<portlist> packet-type { unicast |
nounicast | multicast | broadcast
}{enable | disable}
24. To remark the VLAN attribution of the designated flow, use the
following command.
Command
set policy vlan-remark in acl
zte(cfg)#
<1-400> rule <1-500><1-4094>{nes
ted | replaced{untagged|tagged|all}}
rule <1-500>, if global ACL, only 16 rules is supported.
25. To limit and measure the data flow rate according to the flow,
use the following command.
Command
set policy policing in acl
zte(cfg)#
<1-400> rule <1-500> policer <0-255>
26. To copy the specified data flow to the monitor port, use the
following command.
Command
set policy mirror in acl <1-4
zte(cfg)#
00> rule <1-500>{cpu|analyze-port}
27. To redirect the specified data flow to the user-specified egress
port, use the following command.
Command
set policy redirect in acl
zte(cfg)#
<1-400> rule <1-500>{cpu|port
<portid>}
Function
This configures the
egress rate limit on
gigabit port.
Function
This configures packet
type of port ingress
rate limit on gigabit
port.
Function
This remarks the
VLAN attribution of
the designated flow.
Function
This limits and
measures the data
flow rate according to
the flow.
Function
This copies the
specified data flow
to the monitor port.
Function
This redirects the
specified data flow
to the user-specified
egress port.