Configuration Example; Stp Configuration Example; Figure 50 Stp Configuration Example - Zte ZXR10 2900 Series User Manual

Command
set stp hopmax <1-40>
zte(cfg)#
set stp revision <0-65535>
zte(cfg)#
set stp edge-port {add|delete}
zte(cfg)#
port <portlist>
set stp hmd5-digest
zte(cfg)#
{CISCO|HUAWEI}<0,0x00..0-0xff..f>
set stp hmd5-key {CISCO|HUA
zte(cfg)#
WEI}<0,0x00..0-0xff..f>
show stp
zte(cfg)#
show stp instance [<0-15>]
zte(cfg)#
show stp port [<portlist>]
zte(cfg)#
show stp trunk <trunklist>
zte(cfg)#

Configuration Example

STP Configuration Example

As shown in Figure 50, configure the STP function of switch 1 and
switch 2 , take switch 1 as the root bridge and block a redundant
port in the loop. It realizes loop protection and link backup be-
tween switches.
F 50 STP C
IGURE ONFIGURATION
Configuration of switch:
zte(cfg)#set stp enable
/*enable the stp protocol of switch1 and switch2*/
zte(cfg)#set stp forceversion stp
/*set STP forceversion as stp*/
zte(cfg)#show stp instance
/*show the STP state of switch1 in the system view*/
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 Service Configuration
Function
This sets the maximum
number of hop between
any two terminals of
MST. The default is 20.
This sets version
number of MST.
This adds/deletes edge
port of STP.
This sets stp hmd5
digest.
This sets stp hmd5 key.
This views STP
information.
This views information
of STP instance.
This views information
of STP port.
This views information
of STP trunk.
E
XAMPLE
99