Installing The New Expansion Card; Connecting Cables To The Expansion Card; Installing The Riser Module 2 - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

Figure 134: Removing the expansion card - slot 1
Ê Remove the two screws (1).
Ê Pull out the expansion card from the riser card slot (2).
9.4.6.5

Installing the new expansion card

Ê Install the expansion card as described in section
card" on page
9.4.6.6

Connecting cables to the expansion card

Ê If necessary, connect the cables to the expansion cards as described in
section "Connecting cables to the expansion card" on page
9.4.6.7

Installing the riser module 2

Ê Install the riser module 2 as described in section
2" on page 207.
RX100 S7
205.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Installing the expansion
"Installing the riser module
207.
223