Replacing A Riser Card In Riser Module 2; Required Tools; Preliminary Steps; Removing The Riser Module 2 - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
9.4.9

Replacing a riser card in riser module 2

Field Replaceable Units (FRU)
Average task duration: 5 minutes
V
CAUTION!
Follow the safety instructions in chapter
page 43.
9.4.9.1

Required tools

Preliminary and concluding steps: tool-less
●
Main steps:
●
– slot 1: Phillips PH2 / (+) No. 2 screw driver
– slot 2: Phillips PH2 / (+) No. 2 screw driver
9.4.9.2

Preliminary steps

Ê Perform the following procedures:
1. "Opening the rack door" on page 59
2. "Locating the defective server" on page 55
3. "Shutting down the server" on page 59
4. "Extending/removing the server from the rack" on page 60
5. "Opening the server" on page 64
6. "Locating the defective component" on page 58
9.4.9.3

Removing the riser module 2

Ê Remove the riser module 2 as described in section
module 2" on page
230
213.
Upgrade and Maintenance Manual
"Important information" on
"Removing the riser
RX100 S7