Installing The New Bbu With The Bbu Holder; Concluding Steps - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
9.5.5.8

Installing the new BBU with the BBU holder

Figure 172: Installing the BBU with the BBU holder
Ê Insert the BBU holder into the chassis so that the three shoulder screw caps
on the chassis floor rest in the wide ends of the keyhole slots on the BBU
holder.
Ê Slide the BBU holder in direction of the arrow.
The shoulder screw caps on the chassis floor will lock in the narrow ends of
the keyhole slots on the BBU holder.
Ê Ensure that the locking handle on the BBU holder properly snaps in place
(see circle).
9.5.5.9

Concluding steps

Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Updating RAID controller firmware" on page 84
4. "Enabling SVOM boot watchdog functionality" on page 89
5. "Switching on the server" on page 72
6. "Closing the rack door" on page 73
262 Upgrade and Maintenance Manual
RX100 S7