Switching On The Id Indicator - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

Basic software procedures
Ê After the update or diagnostic procedure has been completed, shut down the
server, reconnect all external I/O connections and bring the system back to
normal operation.
Ê If necessary, perform this procedure for all remaining servers within the
Multipath environment.
5.1.6

Switching on the ID indicator

When working in a datacenter environment, switch on the ID indicator on the
front and rear connector panels of the server for easy identification.
I
For further information, refer to section
page 55 or to the "ServerView Suite Local Service Concept (LSC)"
manual.
Using the ID button on the front panel
Ê Press the ID button on the front panel to switch on the system identification
LEDs.
I
For further information, refer to section
Using ServerView Operations Manager
Ê In ServerView Operations Manager Single System View and press the Locate
button in the title bar to switch on the ID indicators.
80 Upgrade and Maintenance Manual
"Locating the defective server" on
"Front panel" on page 453.
RX100 S7