Installing The Riser Module 1; Concluding Steps - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
9.4.1.6

Installing the riser module 1

Figure 114: Installing the riser module 1
Ê Insert the riser card into the system board slot.
9.4.1.7

Concluding steps

Ê Perform the following procedures:
1. "Closing the server" on page 66
2. "Installing the server in the rack" on page 68
3. "Updating RAID controller firmware" on page 84
4. "Enabling Option ROM scan" on page 85
5. "Enabling SVOM boot watchdog functionality" on page 89
6. "Switching on the server" on page 72
7. "Enabling BitLocker functionality" on page 94
8. "Closing the rack door" on page 73
202 Upgrade and Maintenance Manual
RX100 S7