Connecting The Cables; Concluding Steps - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
7.1.5.6

Connecting the cables

Figure 74: Connecting the cables to the 2.5-inch SAS/SATA backplane
Ê Connect the following cables to the SAS/SATA backplane:
– (1) power cable to connector J4
– (2) SGPIO cable to connector J2
– (3)-(6) SAS/SATA data cables to connectors SATA1, SATA2, SATA3,
SATA4 according the color coding
For the cable plan see section
7.1.5.7

Concluding steps

Ê Perform the following procedures:
1. Insert all HDD/SSD modules, see section
HDD/SSD module" on page
I
Make sure that you reinstall the HDD/SSD module in the bay it
was located before the SAS/SATA backplane replacement.
2. "Closing the server" on page 66
3. "Installing the server in the rack" on page 68
4. "Switching on the server" on page 72
5. "Closing the rack door" on page 73
158
"Cabling" on page
148.
Upgrade and Maintenance Manual
462.
"Installing the 2.5-inch
RX100 S7