Disconnecting The Cables; Removing The Defective 2.5-Inch Sas/Sata Backplane - Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
7.1.5.3

Disconnecting the cables

Figure 71: Disconnecting the cables from the 2.5-inch SAS/SATA backplane
Ê Disconnect the following cables from the SAS/SATA backplane:
– (1) power cable from connector J4
– (2) SGPIO cable from connector J2
– (3)-(6) SAS/SATA data cables from connectors SATA1, SATA2, SATA3,
SATA4
For the cable plan see section
7.1.5.4

Removing the defective 2.5-inch SAS/SATA backplane

Figure 72: Removing the 2.5-inch SAS/SATA backplane
Ê Pull the SAS/SATA backplane upward until the bolts disengage (see circles).
Ê Take out the SAS/SATA backplane.
156
"Cabling" on page
Upgrade and Maintenance Manual
462.
RX100 S7