Fujitsu PRIMERGY RX100 S7 Upgrade And Maintenance Manual page 82

Basic software procedures
Ê Press the On / Off button to start up the server.
The system will detect the USB stick and the BIOS recovery process will be
performed.
V
CAUTION!
Do not interrupt the BIOS upgrade process after it has started. If the
process is interrupted, the system BIOS may be permanently
corrupted.
Ê After completion of the flash process, shut down the server.
Ê Remove the top cover as described in section
page 64.
Ê Disable BIOS recovery mode using the onboard jumpers:
I
For detailed information on jumper settings, refer to section
on page 459
Ê Close the top cover as described in section
iRMC recovery procedure
I
For the Japanese market, follow the instructions provided separately.
Ê Prepare a USB stick including the bootable iRMC firmware update image.
Ê Shut down the server as described in section
page 59 and disconnect it from the mains.
Ê Connect the USB stick to the USB connector.
I
Ensure that only the USB device with the iRMC firmware is connected
to the USB connector. Remove all other USB devices temporarily.
Ê Connect the server to the mains while pushing the ID button on the front
panel. Ask a second person to help you if necessary.
Ê Ensure that the Global Error indicator and the ID indicator are flashing to
indicate that the server is entering the iRMC recovery state.
Ê Press the Power On / Off button. The system starts the POST process.
I
In iRMC reocovery mode, the "FUJITSU" logo does not show up.
82
or the "System Board D3034 Technical Manual".
Upgrade and Maintenance Manual
"Opening the server" on
"Closing the server" on page
"Shutting down the server" on
"Jumper"
66.
RX100 S7