Fast Track Guide
Note:
3.6
Configuring the Trunks
To configure the trunks, take these 13 steps:
Access the Embedded Web Server (refer to Section
1.
Open the 'Trunk Settings' screen ( Advanced Configuration menu > Trunk Settings ); the
2.
'Trunk Settings' screen is displayed.
Initially, the screen appears with the parameters fields grayed (indicating read-only). The
Stop Trunk button appears at the bottom of the screen.
Status indicators.
To configure the parameters of a specific trunk, select the trunk you want to configure by
3.
clicking the Trunk Status indicator corresponding to the trunk number. The first parameter
named 'Trunk ID' changes according to the trunk you selected. The parameters displayed
are for the selected trunk only.
Version 5.0
The following sections from here, up to the end of this Guide,
apply equally to MEGACO, H.323, and SIP.
Figure 3-10: 'Trunk Settings' Screen
Table 3-2: Trunks Status Color-Code Description
Indicator
Color
Gray
Green
Yellow
Red
Blue
Orange
3.3
on page 15).
Table 3-2
Description
Disabled
Active-OK
RAI Alarm
LOS/LOF Alarm
AIS Alarm
D-channel Alarm (ISDN only)
25
3. Configuring the Mediant 1000
describes the Trunk
October 2006