Table 3-33: Trunk Group Settings Parameters - AudioCodes Mediant 600 User Manual

2. From the 'Routing Index' drop-down list, select the range of entries that you want to
edit (up to 24 entries can be configured).
3. Configure the Trunk Group according to the table below.
4. Click the Submit button to save your changes.
5. To save the changes to flash memory, refer to ''Saving Configuration'' on page 193.
An example is shown below of a REGISTER message for registering endpoint "101" using
registration Per Endpoint mode. The "SipGroupName" in the request URI is taken from the
IP Group table.
REGISTER sip:SipGroupName SIP/2.0
Via: SIP/2.0/UDP 10.33.37.78;branch=z9hG4bKac862428454
From: <sip:101@GatewayName>;tag=1c862422082
To: <sip:101@GatewayName>
Call-ID: 9907977062512000232825@10.33.37.78
CSeq: 3 REGISTER
Contact: <sip:101@10.33.37.78>;expires=3600
Expires: 3600
User-Agent: Audiocodes-Sip-Gateway/v.5.80A.008.002
Content-Length: 0
Parameter
Trunk Group ID
[TrunkGroupSettings_Trun
kGroupId]
Channel Select Mode
[TrunkGroupSettings_Chan
nelSelectMode]
Registration Mode
[TrunkGroupSettings_Regis
trationMode]
SIP User's Manual

Table 3-33: Trunk Group Settings Parameters

The Trunk Group ID that you want to configure.
The valid range is 1 to 99.
The method for which IP-to-Tel calls are assigned to channels
pertaining to a Trunk Group. For a detailed description of this
parameter, refer to the global parameter ChannelSelectMode.
[0] By Dest Phone Number.
[1] Cyclic Ascending (default)
[2] Ascending
[3] Cyclic Descending
[4] Descending
[5] Dest Number + Cyclic Ascending
[6] By Source Phone Number
[7] Trunk Cyclic Ascending (applicable only to digital interfaces)
Registration method for the Trunk Group:
[1] Per Gateway = Single registration for the entire device
(default). This mode is applicable only if a default Proxy or
Registrar IP are configured, and Registration is enabled (i.e.,
parameter IsRegisterUsed is set to 1). In this mode, the SIP URI
user part in the From, To, and Contact headers is set to the value
of the global registration parameter GWRegistrationName (refer
to ''Configuring Proxy and Registration Parameters'' on page 108)
or username if GWRegistrationName is not configured.
[0] Per Endpoint = Each channel in the Trunk Group registers
individually. The registrations are sent to the ServingIPGroupID if
defined in the table, otherwise to the default Proxy, and if no
default Proxy, then to the Registrar IP.
176
Mediant 600 & Mediant 1000
Description
Document #: LTRT-83305