Combination Mode; Combi Page Select - Korg M50-88 Parameter Manual

COMBI Page Select

• Press the MODE COMBI switch to select Combination
mode.
You can use the following ways to select the pages in

Combination mode.

1. Press the PAGE SELECT switch to access "Page Select."
"Page Select" shows an abbreviated name for each page.
The page in which you were prior to pressing the PAGE
SELECT switch is shown in grey.
2. Select the desired page in the display.
Other ways to select pages
• Hold down the PAGE SELECT switch and press a
numeric keys, 0–9, to specify a page number; you will
move to the corresponding page.
For example if you want to access the P3: Timbre Param
page, hold down the PAGE SELECT switch and press
numeric key 3.
Note: For pages that consist of multiple subpages, such
as P5–1 and P5–2, or P8–1 and P8–2, the first of these
pages (P5–1 or P8–1) will be selected.
• You can press the EXIT switch to return to the P0: Play
page you selected most recently. Press the EXIT switch
once again to return to the Main page. Press the EXIT
switch to return to the P0: Play page.
Combination mode
Page
Select and play combinations. (☞p.80)
Program selection for each timbre. (☞p.81)
Pan and volume settings etc. for each timbre.
P0: Play (☞p.83)
Simple arpeggiator editing. (☞p.84)
Editing from the Tone Adjust (☞p.86)
Editing from the control surface. (☞p.87)
SW1, 2, and knob function settings. (☞p.91)
P1: Controllers Chord trigger switch note and velocity
settings (☞p.92)
P2: EQ EQ settings for each timbre. (☞p.93)
Various parameter settings for each timbre
P3: Timbre Param (MIDI channel, OSC selection, Pitch setting,
etc.) (☞p.95)
Key split and layer settings.
(Key zone and velocity zone) (☞p.99)
P4: Zone/Delay
Time delay from note-on to beginning of
sound. (☞p.101)
MIDI transmit/receive filter 1 settings.
P5–1: MIDI Filter 1
(☞p.103)
MIDI transmit/receive filter 2 settings.
P5–2: MIDI Filter 2
(☞p.106)
P7: Arpeggiator/ Arpeggiator settings. (☞p.108)
Drum Track Drum track settings. (☞p.111)
Oscillator output bus and master effect send
P8–1: IFX Route1/ level settings. (☞p.113)
1–5 Insert effect routing, selection, and settings.
(☞p.115)
Bus settings for oscillator output. (☞p.117)
P8–2: IFX Route2
Common FX LFO 1, 2 settings (☞p.117)
Master effect routing, selection, and settings.
P9: MFX/TFX (☞p.118)
Total effect selection and settings. (☞p.119)
Main content
79