8-1-4: Ifx1 - Korg M50-88 Parameter Manual

M50 series music workstation
Table of Contents

Advertisement

Bus:
Bus (Bus Select)
Ctrl (FX Control Bus)
Send1/2:
Send1
Send2
For more information, please see "8–2: Insert FX Setup" on
page 66.
▼8–1–3: Menu Command
• 0: Write Combination ☞p.120
• 1: Exclusive Solo ☞p.73
• 2: Copy Insert Effect ☞p.76
• 3: Swap Insert Effect ☞p.76
For more information, please see "Combination: Menu
Command" on page 120.
8–1–4: IFX1
[Off, L/R]
[Off, 1, 2]
8–1
–4a
[000...127]
[000...127]
This page lets you edit the detailed parameters of the five
insert effects. Use the tabs at left to select IFX1 through IFX5.
To select different effects types, use the Insert FX Setup page.
For more information, please see "8–1–3: Insert FX Setup"
on page 114.
8–1–4a: Insert Effect 1 (IFX1)
IFX1 On/Off
Turns the insert effect on/off. This is linked with the on/off
setting in the P8–1: IFX– Insert FX Setup page.
Ch (Control Channel)
This parameter specifies the MIDI channel that will be used
to control effect dynamic modulation (Dmod), pan
following the insert effect (CC#8), Send 1, and Send 2.
The channel number of the timbre routed through this IFX
will be followed by a "*" displayed at the right of Ch01–16.
If two or timbres with different MIDI channel settings are
routed through the same IFX, this parameter specifies which
of these channels will be used to control the effect.
G ch: The global MIDI Channel (Global 1–1a) will be used
to control the effect. Normally you will set this to G ch.
All-R (All Routed): The channel of any timbre routed
through this effect can be used to control the effect.
(Channels of each routed timbre will be indicated by "*".)
Drum Kits and the MIDI Control Channel
If a Timbre is using a Drum Kit, and the Timbre's Bus (IFX/
Output) Select (Combi 8–1–1(2)d) is DKit, this effects the
MIDI Control Channel as well. In this case, the Timbre's
MIDI channel will be used to control any effect whose Ch is
set to All-R, regardless of the Bus (IFX/Output) Select
(Global 5–4b) settings or the settings of the DrumKit IFX
Patch menu command.
P (Effect Preset)
Effect Presets let you easily store and recall all of the settings
for an individual effect. You can store up to 16 user presets
for each effect type, in addition to 15 re-writable factory
presets.
The same presets appear in all of the modes (Program,
Combination, Sequencer, and Sampling).
Note that edits to effects parameters are automatically
stored with the Combi–you don't need to store them as an
Effect Preset. Presets just make it easier to re-use your
favorite settings.
For instance, you can save an Effect Preset while working on
a particular Combination, and then later use the same Effect
Preset in a different Program, Combination, or Song.
COMBI P8–1: IFX 8–1–4: IFX1
[Ch01...16, G ch, All-R]
[P00, P01...15, U00...15, ---------------]
8–1
–4
Menu
[Off, On]
115

Advertisement

Table of Contents
loading

This manual is also suitable for:

M50-73M50-61

Table of Contents