Korg M50-88 Parameter Manual page 195

M50 series music workstation
Table of Contents

Advertisement

5. Since you want the tracks you play via RPPR and the
track you play from the keyboard to be recorded at the
same time, check the Multi REC check box.
Note: If Recording Setup is set to Loop All Tracks, it will
not be possible to select Multi REC. Set the Recording Setup
to Overwrite.
6. Press the SEQUENCER REC/WRITE switch to enter
record-ready mode.
7. For the tracks you will be recording (MIDI Track 1, 2),
press Play/Rec/Mute to make them indicate REC.
Make sure that the tracks you're not recording are indicated
as Play or Mute.
8. Press the LOCATE switch to set the location to
001:01.000.
9. Press the SEQUENCER START/STOP switch, and then
press a key that plays an RPPR pattern.
If, during the pre-count before recording, you press a key
that's assigned to an RPPR pattern, the pattern will begin
playing (and will be recorded) the moment that recording
begins.
Record the RPPR pattern playback and keyboard
performance.
When recording the playback of patterns triggered by
RPPR, the timing of the recorded events may be slightly
skewed. If this occurs, try setting REC Resolution to a
setting other than Hi.
10. When you are finished performing, press the
SEQUENCER START/STOP switch.
Recording will end, and the sequencer will return to the
location at which recording began.
If you made a mistake during your performance or would
like to re-record, you can use the Compare function (press
the COMPARE switch) to re-record as many times as you
wish.
11. If you want to record other tracks, un-check the Multi
REC (See step 5) or "RPPR" (See step 4) check boxes as
necessary.
SEQ P10: Pattern/RPPR 10–3: RPPR Setup
187

Advertisement

Table of Contents
loading

This manual is also suitable for:

M50-73M50-61

Table of Contents