Table of Contents
Advertisement
Sequencer mode
Recording internal parameter changes
You can use SysEx for automation of internal M50 effects
and Program parameters.
As an example, let's record a short phrase on track 1, add an
insert effect, and then record parameter changes for that
effect on an unused track.
In order to record system exclusive messages, make sure
that the Global P1: MIDI– MIDI Routing setting Enable
Exclusive is checked. Go to Global mode and verify that this
is checked.
1. Select the desired program for MIDI track 1, and route
it to IFX1. Then record a phrase of about sixteen mea-
sures.
• In the P0–1: Play/REC– Program T01–08 page, use
"Program Select" to select the desired program for MIDI
Track 01.
• In the P8–1: IFX– Routing1 T01–08 page, route the MIDI
Track 01 Bus (IFX/Output) Select to IFX1. Then in the
P8–1: IFX– Insert FX Setup page, select the desired effect
for IFX1.
• Select MIDI Track 01 in Track Select. Then press the
SEQUENCER REC/WRITE switch and then the START/
STOP switch, and record a phrase of about sixteen
measures.
2. Select Track 09 in "Track Select," and record parameter
changes as desired.
Note: For this example, select an empty track. If you want to
record onto a MIDI track that already contains data, set the
P0–1: Play/REC– Preference page Recording Setup to
"Overdub," as described on page 138.
• Select Track 09 in Track Select. Then press the
SEQUENCER REC/WRITE switch and then the START/
STOP switch, and begin recording.
• At the appropriate time while recording, adjust the
parameter(s) that you want to realtime-record.
212
Select another effect for IFX1 in the P8–1: IFX– Insert FX
Setup page, and edit the effect parameter values, or use the
P0–1: Play/REC– Tone Adjust controls to edit the sound in
realtime.
Note: For details on the effects parameters that you can
record in real-time, please see "Parameter change messages
that you can realtime-record in Sequencer mode" on
page 211.
3. Stop recording.
Note: Exclusive messages are always recorded on the
current track selected by Track Select. In this example, they
are recorded on MIDI track 9.
Note: In the MIDI event edit page you can view the recorded
exclusive events and their location. Exclusive events are
displayed as "EXCL".
To view these events, go to the P6: Track Edit– Track Edit
page, and select the menu command MIDI Event Edit. Then
in the Set Event Filters dialog box, check Exclusive and press
the OK button.
Exclusive events cannot be changed to a different type
of event. Nor can other events be changed into
exclusive events.
4. If you go to the page (e.g., P8–1: IFX) that shows the
parameters you adjusted in realtime, you can watch the
recorded changes be reproduced while the song plays
back.
Advertisement
Table of Contents
