005: Stereo Gate - Korg M50-88 Parameter Manual

M50 series music workstation
Table of Contents

Advertisement

005: Stereo Gate

This effect mutes the input signal when it falls below a
specified level. You can also invert the on/off status of the
gate, or use note-on/off messages to turn the gate on/off
directly.
Stereo In - Stereo Out
Left
Envelope Source
Side PEQ
Envelope - Control
+
Envelope - Control
Envelope Select
D
-mod
Right
FX Control BUS 1
FX Control BUS 2
Selects the source to control
D-mod,
the gate: D-mod control, or use
Envelope
Input,
the input signal or FX Control
Source
FX Control 1,
Bus 1 or 2 as a trigger
a
FX Control 2
Sets the trigger input level from
Fx Ctrl Trim
0...100
FX Control Bus 1/2
L/R Mix,
Selects the control signal: left
Envelope
L Only,
and right linked, left only, or
Select
R Only
right only
b
Selects the source that will
Src
Off...Tempo
control the gate when
Envelope Src = D-mod
Sets the level at which gating is
Threshold
0...100
applied
c
Switches the polarity of gating
Polarity
+, –
Attack
1...100
Sets the attack time
d
Release
1...100
Sets the release time
e Delay Time
Sets the delay time for the gate
0...100
[msec]
input
Side PEQ
Switches the trigger signal
Off, On
Insert
equalizer on/off
f
Switches between monitoring
Trigger
Off, On
the effect output and the
Monitor
trigger signal
Sets the center frequency of
Side PEQ
20...12.00k
the equalizer for the trigger
Cutoff [Hz]
signal
Sets the bandwidth of the
g
Q
0.5...10.0
equalizer for the trigger signal
–18.0...+18.0 Sets the gain of the equalizer
Gain [dB]
for the trigger signal
Dry, 1 : 99...
Sets the balance between the
Wet/Dry
99 : 1, Wet
effect and the dry input
Selects a modulation source for
h
Src
Off...Tempo
Wet/Dry
Sets the modulation amount
Amt
–100...+100
for Wet/Dry
c: Threshold
d: Attack
d: Release
Threshold specifies the level at which gating occurs when
Envelope Select is set to L/R Mix, L Only, or R Only.
Attack and Release specify the attack time and release time
of the gate.
Wet / Dry
Gain Adjust
Delay
Gate
Trigger Monitor
Delay
Gate
Gain Adjust
Wet / Dry
p.291
p.291
p.293
p.293
p.293
p.293
p.293
p.291
p.291
p.291
p.291
p.291
Output Level
Threshold
Dry
Wet
Wet
Attack
c: Polarity
This inverts the polarity of the gate on/off operation. With
the "–" setting, the gate will close when the input signal
exceeds the specified level. The direction in which the
modulation source opens or closes the gate will also be
reversed.
e: Delay Time [msec]
This sets the delay time for the input to the gate. When using
shorter Attack Time settings, you can lengthen the Delay
Time so that the sound is input after the gate opens.
Dynamics (Dynamic)
Gate - Threshold
Louder
Input Level
Gate - Attack / Release
Threshold
Attack=1
Release=1
Attack=100
Release=100
Release
293

Advertisement

Table of Contents
loading

This manual is also suitable for:

M50-73M50-61

Table of Contents