Korg M50-88 Parameter Manual page 206

M50 series music workstation
Table of Contents

Advertisement

Sequencer mode
Set Song Length
This command changes the length of the specified song.
When it is executed, the length of the master track will
change, and the number of measures played will change.
1. In Length, specify the length of the song.
All data following the measure specified by Length will
be deleted.
Erase Track
This command erases the data from the specified track.
However, it is not possible to erase the master track by itself.
1. In Track Select, select the track that you wish to erase.
2. Select "Erase Track" to open the dialog box.
3. Select the track whose data you want to erase.
If you don't check All Tracks, the data will be erased only
from the tracks you specify in Track Select.
If you check All Tracks, the musical data of all tracks will be
erased.
Copy Track
This command copies musical data from the copy source
track to the specified track.
Be aware that the track data of the copy-destination will be
erased when you execute the Copy Track operation.
1. Use Track Select to select the MIDI track (Track 01–16)
that you want to copy.
2. Select "Copy Track" to open the dialog box.
3. Use the From field to select the copy-source track, and
To to select the copy-destination.
(By default, the track you choose in Track Select will be
specified for From.)
198
Bounce Track
This command combines the musical data of the source and
destination tracks, and places the combined data in the
bounce destination. All musical data in the source track will
be erased.
If MIDI control data exists in both the source track and
destination track, unexpected results may occur during
playback after the bounce command is executed. To prevent
this from happening, use Event Edit or Erase Control Data
to edit the MIDI control data of the two tracks before you
use Bounce Track.
1. Use Track Select to select the MIDI track (Track 01–16)
that you want to bounce.
2. Select "Bounce Track" to open the dialog box.
3. Use the From field to select the source track, and To to
select the destination track.
(By default, the track you choose in Track Select will be
specified for From.)
In the case of Bounce Track, the source track data will be set
to "zero".
Erase Measure
This command erases the specified type(s) of musical data
from the specified range of measures. The Erase Measure
command can also be used to remove only a specific type of
data. Unlike the Delete Measure command, executing the
Erase Measure command does not cause the subsequent
measures of musical data to be moved forward.
1. Use Track Select to select the MIDI track (Track 01–16),
master track that contains the measures of data you
want to erase.
2. Select "Erase Measure" to open the dialog box.
3. In From Measure select the first measure to be erased,
and in To End of Measure select the last measure to be
erased.
(By default, From Measure and To End of Measure will be
set to the range that you specified in the Track Edit page.)
4. If you are erasing MIDI data, use Kind to specify the
type of data that will be erased.
All will erase all types of data in that track, Note will erase
note data, Control Change will erase control change data,
After Touch will erase both channel pressure and poly key
pressure data, Pitch Bend will erase pitch bend data,
Program Change will erase program change data, and
Exclusive will erase exclusive data.
5. Specify the track(s) on which you want to execute the
command.

Advertisement

Table of Contents
loading

This manual is also suitable for:

M50-73M50-61

Table of Contents