5-3: Driver/Eq - Korg M50-88 Parameter Manual

Global mode
DS2(M Hi): (Drumsample2 Mid High)
DS3(M Lo): (Drumsample3 Mid Low)
DS4(Low): (Drumsample4 Low)
Here, you can edit the sample parameters for the second,
third, and fourth drum samples. For more information,
please see "DS1 (High): (Drumsample 1 High)," above.
▼5–2: Menu Command
• 0: Write Drum Kits ☞p.255
• 1: Rename Drum Kit ☞p.255
• 2: Copy Drum Kit ☞p.255
• 3: Copy Key Setup ☞p.255
• 4: Swap Key Setup ☞p.255
For more information, please see "Global: Menu Command"
on page 251.
236
5–3: Driver/EQ
5–1a
5–3a
Here, you can adjust the gain of the three-band EQ for each
drum sample. These are offsets that are added to the settings
of the program.
5–3a: Driver/EG
DS1 (High): (Drumsample 1 High)
DS1(High) On/Off
This parameter is linked with "5–1b: Drumsample" DS1.
On (checked): Check this if you want to use DS1 (High). The
selected drum sample will sound.
Off (unchecked): DS1 (High) will not be used. The drum
sample will not sound.
Drive
This adjusts the drive level. This offset value for each key
and drum sample is applied to the driver Drive (Prog 4–1a)
setting of the programs that use this drum kit.
Low Boost (Driver Low Boost)
This adjusts the low boost level of the driver. This low boost
setting for each key and drum sample is applied to the
driver Low Boost (Prog 4–1a) setting of the programs that
use this drum kit.
3 Band Parametric EQ [dB]
Low
Mid
High
These parameters adjust the gain for each band of the three-
band parametric EQ. The gain settings for each key and
drum sample are applied to the LowGain, MidGain, and
HighGain (Prog 4–8a) settings of the programs that use this
drum kit.
DS2(M Hi): (Drumsample2 Mid High)
DS3(M Lo): (Drumsample3 Mid Low)
DS4(Low): (Drumsample4 Low)
Here, you can edit the sample parameters for the second,
third, and fourth drum samples. For more information,
please see "DS1 (High): (Drumsample 1 High)," above.
5–3
Menu
[Off, On]
[–99...+99]
[–99...+99]
[–36.0...+36.0]
[–36.0...+36.0]
[–36.0...+36.0]