7–2: ARP Scan Zone
7–2a: Arpeggiator Tempo
For more information, please see " (Tempo)*" on page 59.
7–2b: Zone Map
This shows the Scan Zone.
Key zone of arpeggiator
7–2c: Scan Zone
This shows the Scan Zone setting.
These parameters specify the range of notes (keys) for which
the arpeggiator will function. Top Key is the upper limit,
and Bottom Key is the lower limit.
The arpeggiator will operate when you play keys within the
speciﬁed range. Keys outside of this range can be played in
the normal manner, and will not be affected by the
For example if you set Pattern to P0: UP, check Latch, set
Top Key to B3, and Bottom Key to C-1, playing a note B3 or
lower will trigger the arpeggiator. Since Latch is on, the
arpeggio will continue even after you release the keys. You
can use the C4 and higher keys to play conventionally along
with the arpeggio sounded by the B3 and lower keys. To
change the arpeggio, play keys in the range of B3 and below.
Speciﬁes the range of velocities for which the arpeggiator
will function. Top Velocity is the upper limit, and Bottom
Velocity is the lower limit.
The arpeggiator will operate when you play notes with a
velocity (playing strength) that is within the speciﬁed range.
Notes played with a velocity outside this range will be
sounded normally, without regard to the arpeggiator on/off.
Note: Note number and velocity can also be entered by
holding down the ENTER switch and playing a note on the
PROG P7: ARP/DT (Arpeggiator/Drum Track) 7–2: ARP Scan Zone
Velocity zone of
▼7–2: Menu Command
• 0: Write Program ☞p.73
• 1: Exclusive Solo ☞p.73
For more information, please see "Program: Menu
Command" on page 73.