Initialization - Avaya S8700 Maintenance Manual

MAPD-BD (MAPD Interface Circuit Pack TN802)
Replacing the Hard Disk
The TN802 hard drive (Note 5 in
Table 8-298. Replacing the TN802 hard drive
Step Description
1. Shut down NT.
2. Remove the circuit pack.
3. Remove the hard drive.
4. Replace the hard drive.
5. Replace the circuit pack.
6. Wait for initialization.
555-233-142
Figure 8-18) is field-replaceable.
Comments
Shut down Windows NT by either method
described in the ''Shutting Down NT on the
TN802'' section.
Unlatch the circuit pack, and remove it from the
carrier.
Remove the 2 screws, and lift the hard drive out
of its mounting bracket.
Position the new hard drive in the mounting
bracket, and replace the 2 screws (Step 3).
Slide the circuit pack into the slot, and lock the
latching lever.
Wait for:
the circuit pack to reseat (faceplate LEDs
light then go out
Windows NT boots (PC BOOT displays on
the faceplate LCD)
IP Trunk application to run (IP TRK # displays
on the faceplate LCD)
Issue 1 May 2002
Continued on next page
8-727