Avaya S8700 Maintenance Manual page 33

MAPD-BD (MAPD Interface Circuit Pack TN802)
Table 8-299. MAPD (TN802) Error Log entries — Continued
Error Aux
Type Data Associated Test
3073 to Any Slip Alarm Inquiry test
3160 (#144)
(m)
3330 (n) 46083
3585 to Any Misframe Alarm Inquiry
3601 (o) test (#145)
3840 (p) Any None
3841 (q) 4358
3842 (r) 46097
3843 (s) 46081
3999 (t) Any None
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test's description, and follow its recommended procedures.
2. If ports are assigned to the circuit pack, then a minor alarm is raised. If no ports are assigned to the circuit pack,
then a warning alarm is raised. The alarm is raised after the circuit pack has been missing for a period of 15
minutes. Warning alarms are also raised against any ports administered on the circuit pack.
3. Major alarms on this MO may be downgraded to minor or warning alarms based on values set in the set options
command.
Notes:
a. Error Type 1—Indicates that the circuit pack has totally stopped
functioning or is not fully administered. The alarm is logged about 15
minutes after the circuit pack has been removed or 11 minutes after the
SAKI test (#53) fails.
To be fully administered, a MAPD circuit pack must meet all of these
conditions:
If the circuit pack has an entry in the circuit plan and either of the other two
conditions are not met, a MINOR alarm is logged. To resolve the error,
either:
1. Make sure the circuit pack is properly administered and that a
555-233-142
Alarm
Level
MIN/
WRN
MIN/
WRN
MIN/
WRN
Have an entry in the circuit plan (change circuit pack)
Be administered (add ds1 UUCSS)
Be physically inserted into the correct slot
functioning MAPD circuit pack is inserted in the correct slot
or
On/Off
Board Test to Clear Value
OFF test board UUCSS r 6
3
ON
3
OFF test board UUCSS r 6
3
Continued on next page
Issue 1 May 2002 8-729