Avaya S8700 Maintenance Manual page 472

Maintenance Object Repair Procedure
Transmission Test (#844-848)
This test is nondestructive.
NOTE:
Tests #844–848 are not supported on an International switch.
These tests are run by the Automatic Transmission Measurement System
(ATMS). They are not part of the long or short trunk test sequences. Instead,
they are run on demand with the test analog-testcall command or as part of
ATMS scheduled testing. For more information, see
Measurement System''
The test call is run from an analog port on a TN771 Maintenance/Test circuit pack.
It attempts to seize a port and make a call to a terminating test line (TTL) on the
trunk's far end. Transmission performance measurements are made and
compared to administered thresholds. Errors are generated when results fall
outside of "marginal" or "unacceptable" thresholds. Detail and summary
measurement reports are obtainable via the list testcalls command.
Table 8-498. Test #844-848 Transmission Test
Error Test
Code Result Description / Recommendation
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call.
1. Use display port UUCSSpp to determine the trunk group/member number
2. If the port status is idle, then retry the command at 1-minute intervals up to
1001 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1002 ABORT The system could not allocate timeslots for the test. The system may be under
heavy traffic conditions or it may have timeslots out of service due to TDM bus
errors.
1. If the system has no TDM bus errors and is not handling heavy traffic,
1004 ABORT The port has been seized by a user for a valid call. Use status trunk to
determine when the port is available for testing.
1. Retry the command at 1-minute intervals up to 5 times.
8-1168 Issue 1 May 2002
in Chapter 6.
of the port. Use the "status trunk" command to determine the service state
of the port. If the service state indicates that the port is in use, then the
port unavailable for this test. (Refer to section on "status" commands for a
full description every possible state). You must wait until the port is idle
before retesting.
5 times.
repeat test at 1-minute intervals up to 5 times.
''Automatic Transmission
Continued on next page
555-233-142