Avaya S8700 Maintenance Manual page 398

Maintenance Object Repair Procedure
Table 8-469. Test #1243 Layer 3 Query — Continued
Error Test
Code Result Description / Recommendation
1139 ABORT The Packet bus in the port network is out-of-service.
1. Follow the repair procedures for the Packet bus.
2. After completing step 1, execute the test port long UUCSSpp command
1141 ABORT The PKT-CTRL is out-of-service.
1. Consult the repair procedure for PKT-CTRL.
2. If Step 1 does not resolve the problem, escalate to the next tier.
1187 ABORT The circuit pack or port may have been busied out by a technician.
1. Look in the Error Log for Error Type 18 (busied out) for TBRI-BD or
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
2012 ABORT Internal system error
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
PASS The switch has successfully sent a Status Enquiry message.
8-1094 Issue 1 May 2002
and review the results of the BRI Port Local LAN Loop-around test to verify
the repair.
TBRI-PT.
a. If this error type is present for TBRI-PT, then release the port with the
release port UUCSSpp command and run the test again.
b. If the error is present for both TBRI-BD and TBRI-PT, then release the
circuit pack with the release board PUUCSS command and run the
test again.
NOTE:
When you release the circuit pack, you release every port associated
with it. If certain ports still need to be busied out, use the busyout port
UUCSSpp command to busy them out.
Continued on next page
555-233-142