Avaya S8700 Maintenance Manual page 649

VAL-PT (Voice Announcements over LAN Packet/Port)
SCOTCH Synchronous Loop-Around Test (#1275)
This test is destructive.
This test verifies the circuit in the data path of a VAL announcement port call. This
test fails if the data transmitted on the port does not match the data received in the
loop-around mode. Failure of this test indicates a port hardware fault on the
circuit pack.
This test aborts if calls are using the port, or if the VAL link associated with the
port is connected. To avoid this, at the SAT type busyout port UUCSSpp, which
tears down every call and link using the port.
Table 8-558. Test #1275 SCOTCH Synchronous Loop-Around Test
Error Test
Code Result Description / Recommendation
1000 ABORT The port is in use.
1. Retry the command when the port is idle. You can force the port to the idle
1002 ABORT No TDM bus timeslots available for the test.
1. Retry the command at 1-minute intervals up to 5 times.
2. Escalate if the problem persists.
1963 ABORT The port is in use.
1. Retry the command when the port is idle. You can force the port to the idle
2000 ABORT Did not receive circuit pack test response within the allowable time period.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2. Escalate if the problem persists.
2100 ABORT Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals up to 5 times.
2. Escalate if the problem persists.
555-233-142
state with the busyout port UUCSS command.
This command is destructive, tearing down every call and link using the
port.
state with the busyout port UUCSS command.
This command is destructive, tearing down every call and link using the
port.
If this problem persists, reset the circuit pack (busyout board UUCSS,
reset board UUCSS, and release board UUCSS).
If the problem persists, replace the circuit pack.
Continued on next page
Issue 1 May 2002 8-1345