Avaya S8700 Maintenance Manual page 395

TBRI-PT (ISDN Trunk-Side BRI Port)
The Deactivated state indicates a problem with the TBRI-BD circuit pack. When
in this state, the Level 1 interface is not active, and an idle signal is transmitted to
the channels or that Layer 1 was deactivated by the switch. When an TBRI-PT
port is placed in the out-of-service state, Level 1 is also put into the Deactivated
state. This could be due either to the system detecting a fault with the port or to a
busyout port UUCSSpp request.
Table 8-468. Test #1242 Level 1 Status Inquiry
Error Test
Code Result Description / Recommendation
1187 ABORT The board or port may be busied out.
1. Look in the Error Log for Error Type 18 (port busied out) for this port and
2. Make sure the endpoint is connected.
3. Retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response to the test was not received from the circuit pack within the allowable
time period.
1. If the test aborts repeatedly up to 5 times, reset the circuit pack with the
2. If the test aborts again, replace the circuit pack.
2012 ABORT Internal system error
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
555-233-142
TBRI-BD (board busied out). If this error type is present for TBRI-PT only,
then release the port with the release port pp command and run the test
again. If the error is present for both TBRI-BD and TBRI-PT, then release
the board with the release board UUCSS command and run the test
again.
NOTE:
When you release a board, you release every port associated with it. If
certain ports still need to be busied out, use the busyout port
UUCSSpp command to busy them out.
busyout board UUCSS, reset board UUCSS, and release board
UUCSS commands.
Continued on next page
Issue 1 May 2002 8-1091