Avaya S8700 Maintenance Manual page 277

PPP-PT (Control LAN Packet/Port)
Table 8-410. Test #1286 Session Status Test
Error Test
Code Result Description / Recommendation
1124 ABORT PPP link is not enabled.
1. Verify that the ppp link is enabled (status port UUCSSpp, status link n, or
2. If the link is not enabled, enable the link (change data-module).
3. Repeat the test.
4. Escalate if the problem persists.
1125 ABORT PPP link not in service.
1. Verify whether PPP link is in service (status port UUCSSpp or status link
2. If the PPP link is not in service, release the link (release link n or release
3. Repeat the test.
4. Escalate if the problem persists.
2000 ABORT Did not receive circuit pack test response within the allowable time period.
1. If the problem persists, reset the circuit pack (busyout port UUCSSpp,
2. If the problem persists, replace the circuit pack.
2100 ABORT Could not locate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. Escalate if the problem persists.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2. Escalate if the problem persists.
1 FAIL System software indicates at least one PPP link session is down (SOME UP).
1. Isolate downed sessions (status port UUCSSpp or status link n).
Follow actions based on session information.
2 FAIL System software indicates every PPP session is down (ALL DOWN).
1. Test the port (test port UUCSSpp) to verify the SCOTCH Synchronous
2. If test passes, wait for system software to indicate ALL UP.
3. If the test fails, check the destination and other components in the path.
4. If the destination and other components in the path are in-service, take
PASS Every session up.
555-233-142
display data-module).
n).
port UUCSSpp).
reset board UUCSS, and release board UUCSS).
Loop-around test (#1275) result.
action based on session information.
Continued on next page
Issue 1 May 2002 8-973